Case Colt Ingersoll Tractors banner
3 point hitch
1-4 of 6 Results
  1. NEW MEMBER Introductions
    Hello all, I recently bought an old 4016 and have been doing some work to it to get it ready for a new property, iv found your discussions helpful to be sure! I replaced the feed hose to the 3 pt lift cylinder for the HH34 hitch and now the cylinder is leaking pretty good around the shaft... I...
  2. Workshop
    I referred to it in a post about my new front weight bracket, but here's the 3 point carry-all that I fabricated a couple weeks ago. In order to determine its maximum capacity, and because I needed these bricks moved, I loaded it with bricks just until the front wheels came off the ground...
  3. Workshop
    I made a front weight box to counterbalance my new 3-pt. hitch carryall. About a year ago I came into about 20 pieces of 7 foot long 1/2" steel track. I haven't found any other good use for it yet, so I decided to make it into a 3point carryall for the rear, and a weight box that's configured as...
  4. Workshop
    My stab at a Case HH34 three point hitch. It's pretty close to the factory specs with a couple exceptions: I chose Cat 1 (which I THOUGHT was 3/4" ID) lift arm ends instead of the 5/8" ID Cat 0. That way I can hook up to either Cat 1 or Cat 0 implements. And I had to make some allowances for...
1-4 of 6 Results
Top