Search Results for ‘case’

Hello again. Some of you may have seen my last post about my Case 448 black frame Onan p218g. The Onan has a very slight ticking sound coming from the engine, it seem to be more audible from the left side of the engine. On my last post the Extremely helpful members guided me to check a few...

Hello I have a case 448 with a onan pc18g engine. It runs fine with it brand new nikki carb, but there is a noticable ticking noise in the engine. I know its not a knock as it is quiet but noticable. There is no lose of power or engine problems at all. In fact if you were wearing headphones you...

hello is there a way to fit a 3 point linkage to a case 150 thanks :thumbsup::thumbsup::thumbsup::thumbsup::thumbsup::thumbsup::thumbsup::thumbsup::thumbsup::thumbsup::thumbsup::thumbsup::thumbsup::thumbsup::thumbsup::thumbsup:

i am looking for a piston arm for a kohler 241 engine and other various please reply to this if you have any preferably genuine parts :thumbsup:

I have a 646 1975. I replaced oil pump about ten hours use ago. Got all my power back. I was pushing some brush and suddenly no power to move forward or backward. Loader goes up lethargically. This morning went out to see if it would move and it does very slowly almost to the point of...

I have a 79 Case 444 which I am going through to make everything work properly. I am working on repairing the hydraulics as the old hydraulic hoses have brittle sheathing to the point that there is no more sheathing on the lines. The issue I have is with the hydraulic lift hoses. I wanted to...

My problem is my 220 has a significant loss of power in the forward gears both HI and LO. although i seem to have plenty of power in reverse and full speed in HI gear in reverse as well. Tractor has newly rebuilt Kohler 16HP engine and newly installed holding valve. I hear the relief valve...

Here you go... :usa2: These are factory spacers for a very rare wide wheel option for 400 series tractors.

I recently purchased a 1985 Case (Ingersoll Rand) 448 GT. I am trying to learn more about how implements (e.g. snow blower, blade) are hydraulically lifted on the front of the GT, as well as how a Roto-tiller is hydraulically lifted on the rear of the GT. Are 'all' implements lifted with the...