Search Results for ‘onan’

Evening y'all, I have been rebuilding a very neglected and haphazardly repaired 3016PS. I also own a 4016. Both engines have a '90 P216 and have had the flyball spacer replaced. The 3016 starts easy and runs excellent, but has issues restarting when hot. When the weather was in the mid 70s the...

Bought a 446 back in the spring. It had a small hydraulic leak by the tank and was missing the air breather assembly. I have started it up and drove it very little because I had a make shift air filter on it. This is just a toy for me and I don't need it to mow weekly. Finally bought a complete...

Hello again. Some of you may have seen my last post about my Case 448 black frame Onan p218g. The Onan has a very slight ticking sound coming from the engine, it seem to be more audible from the left side of the engine. On my last post the Extremely helpful members guided me to check a few...

Hello I have a case 448 with a onan pc18g engine. It runs fine with it brand new nikki carb, but there is a noticable ticking noise in the engine. I know its not a knock as it is quiet but noticable. There is no lose of power or engine problems at all. In fact if you were wearing headphones you...

I had problems with my starter a while back so I took it out cleaned it and lubed it and it worked a couple times. Now it just whirs without engaging the flywheel unless I hold the key on for up to a minute. Sometimes it works and sometimes it doesn't. I don't use it much in the summer, usually...

I've had a 1973 Case 442 since 2008. It has served me very well, and been very reliable. In the 12 years I've had it I've done routine maintenance, relined the PTO clutch, and replaced the plastic fan, the drag link ball sockets, and the fuel pump. Not too shabby. Lately I built a 3 point...

Hi All, I have a Case 446 with a Onan n52M 19hp opposed twin engine. Symptom: When I am running the tractor hard with a hydraulic tiller attachment after about 30 minutes it dies then after start again it has barely enough power to limp to the garage. Things that I have done: Changed fuel...

I have an Onan engine that exhibits symptoms of an intake valve issue (I suspect a valve guide problem). I am planning to tear it down to inspect and hopefully repair soon. Can anyone tell me if this valve spring compressor will work for removing and installing Onan valves - ( Lisle 23330 )...

All right guys, I'm going to stir up some debate here. I have a Case 446 with the original Onan engine in it. It's been sitting for 20+ years, is covered in oil, and doesn't appear to have been very well maintained. I've partially disassembled the engine, and the cylinder walls do look decent...