Case Colt Ingersoll Tractors banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I have a 195 im restoring. It has hydraulic lift and tiller pto valve with flow control. I dont understand the manual. Can someone tell me the hydraulic line routing from start to finish
 

·
Administrator
Joined
·
6,486 Posts
To understand the routing,, there are 2 manuals to consider looking at.


Page 10 on this manual, shows how to go from pump, how to go from pto valve to tiller motor, and from valve, over to the TCV.

I find for the 195, there are (to me anyways) 3 sections to the routing.

The PTO, which is found in the tillers section, attached above

The TCV which is found in the main section of the prats manual, page 34/35

The separate hydraulic lift, was an added feature, that is found in the same parts manual as well,, but it's virtually the last section with parts/diagrams. Page 56 attached just below this line.


The hydraulic tank, doubles as the differential case for the rear axle.

Have you gone through this post? Lots of pictures in there,,

 
1 - 2 of 2 Posts
Top