Case Colt Ingersoll Tractors banner
1 - 8 of 8 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
So I was cutting on the 446 and it suddenly died, no warning. Nothing on the dash will light up when I turn on the ignition and it will not crank, not even a click. The horn will blow. I know the battery is good. Any ideas?
 

·
Registered
1993 Ingersoll 4118
Joined
·
233 Posts
If you haven't already done so, check the main 30amp fuse, if that's good, start checking for power to the ignition. Then start checking for power through the safety switches.
 

·
Registered
Joined
·
14 Posts
Discussion Starter · #3 ·
Thanks for the ideas. I looked previously for a fuse but could not locate any. Where is it?

Sent from my SM-P600 using Tapatalk
 

·
Registered
1993 Ingersoll 4118
Joined
·
233 Posts
Should be a 30amp. I guess I would throw one in and see what happens
 

·
Registered
Joined
·
14 Posts
Discussion Starter · #6 ·
Will pick some up in the AM and try. Did notice that the wire to the headlights may have melted on the exhaust and could be shorting. Put some electrical tape on it and re routed. Thanks for the info Timj.
 
1 - 8 of 8 Posts
Top