Case Colt Ingersoll Tractors banner
1 - 8 of 8 Posts

·
Registered
Joined
·
1,211 Posts
Discussion Starter · #1 ·
The cylinder kits are about $100 each at M&D, C26444 bucket and C26445 arms. The bucket is a 2.5" bore, the arms are 2". 2.5" piston cups with a 3/4" hole were "9250-075F" at $9.76 ea. 2" piston cups with a 5/8" hole "9200-062F" at $8.60 ea. Wiper is a "ST-125', 1.25" x 1 5/8" x 3/16" at $3.11. Rod seal cup "RTU18-1.25-31", 1.25 x 1 5/8 x 5/16 at $6.52.

www.hddistributors.com

Shipping was quick. Prices were good. Selection very good. Web site not so good, ordered over the phone.
 

·
Banned
Joined
·
12,618 Posts
Sorry. Your post implied that it was the backhoe attachment that you were wishing to rebuild. If you are working on the loader arm lift cylinders and the single bucket cylinder, then the information by Mike should help you out.
 

·
Registered
Joined
·
1,211 Posts
Discussion Starter · #7 ·
Well, he said bucket cylinders so not sure which way or not that is.

The curl cylinder is a 2.5" bore and the arms are 2" bore. Dont remember what the rod size was. I do know that to take the cylinder apart is very easy. Drop the roll pins out, knock the pin out, then take a punch or a pin wrench and get the gland off the top of the cylinder and the rod will come off with
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top