Case Colt Ingersoll Tractors banner
1 - 5 of 5 Posts

·
Registered
Joined
·
1,462 Posts
Discussion Starter · #1 ·
I haven't got mine out yet, but they are really loose. Does anyone know the dimensions? ie: are they a standard ID/OD or do I need to go to Ingersoll (Brian).

Also, these have thrust washers top and bottom of the spindle. Anyone ever look for and find a needle bearing replacement?
 

·
Registered
Joined
·
1,462 Posts
Discussion Starter · #3 ·
The problem with this is that there is very little vertical distance available. Just two thin thrust washers. So I was wondering if anyone has found one thin enough. I haven't so far.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top