Case Colt Ingersoll Tractors banner
1 - 3 of 3 Posts

·
Registered
Joined
·
376 Posts
Discussion Starter · #1 ·
How much space should be allowed between the loader arm and tower?

I put a new shaft on mine with the original collars and hole spacing, but noticed that I have a lot of gap between arm, tower and collar. I’m thinking of cutting a collar that extends a little longer to push the arms a bit closer to the tower. The same could be accomplished with some washers.

The question is, how much spaced should there be? I don’t want it to bind and also don’t want to remove any play that might be there by design.








Sent from my iPhone using Tapatalk
 

·
Senior Member
'68 - Case 155, '73 - 646a
Joined
·
1,986 Posts
Best picture I have and measurements are I'm this post
 
1 - 3 of 3 Posts
Top