Joined
·
376 Posts
How much space should be allowed between the loader arm and tower?
I put a new shaft on mine with the original collars and hole spacing, but noticed that I have a lot of gap between arm, tower and collar. I’m thinking of cutting a collar that extends a little longer to push the arms a bit closer to the tower. The same could be accomplished with some washers.
The question is, how much spaced should there be? I don’t want it to bind and also don’t want to remove any play that might be there by design.
![]()
![]()
![]()
Sent from my iPhone using Tapatalk
I put a new shaft on mine with the original collars and hole spacing, but noticed that I have a lot of gap between arm, tower and collar. I’m thinking of cutting a collar that extends a little longer to push the arms a bit closer to the tower. The same could be accomplished with some washers.
The question is, how much spaced should there be? I don’t want it to bind and also don’t want to remove any play that might be there by design.
Sent from my iPhone using Tapatalk
