Case Colt Ingersoll Tractors banner
1 - 2 of 2 Posts

·
Registered
Joined
·
341 Posts
Discussion Starter · #1 · (Edited)
The original tube on my 646 had a deep wear point that was brazed in the past. I didn’t feel good running it and wasn’t confident in yet another repair.





I located a C47478 hose kit to replace the tube. The parts could fairly easily be located locally, but this was just an easy way to handle this.



Anyhow, my question is, does anyone have a picture of this installed?

There are multiple options for routing. The space is tight and will only get worse as I add more pipes, pedals and the banana plate assembly. I am expecting to have to do some trial and error, so was hoping someone had a picture to save me some grief.





Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
341 Posts
Discussion Starter · #2 ·
Looking in the parts manuals I see that this arrangement with two elbows and a soft line is actually meant for an Ingersoll 7020. If anyone can snap a picture of the underneath TCV area of their 7020 it might be a help for me. I have one route that might work, but it's tricky getting the hose bent just right and not in a position where it will get cut on the frame or brake mechanism.
 
1 - 2 of 2 Posts
Top