Case Colt Ingersoll Tractors banner
1 - 2 of 2 Posts

·
Registered
Case 648BH
Joined
·
50 Posts
Discussion Starter · #1 ·
so of course I need forks for my 648BH and of course I don't have any money to do this. I've read a bunch of posts about folks using or copying the ll20 design which look really nice. I've also looked at the clamp on style but realize these have significant limitations and I'd rather not use them. a PO of my machine welded tabs to the interior of the bucket that seem like would make good receivers for forks. has anyone seen this before? any other ideas on how to get forks on here? I don't weld so that is not a current option. but seems like at some point it will be necessary to fully realize the potential of this tractor;)

tks



Wood Road surface Asphalt Rectangle Gas
Branch Wood Asphalt Road surface Beige
Brown Wood Beige Tints and shades Composite material

e them. a PO on my machine welded tabs to the interior of the bucket
 

·
Registered
Case 648BH
Joined
·
50 Posts
Discussion Starter · #3 ·
Looks like I can get some fork extensions for the short term. I have some stacked lumber I had milled that I need to lift. Long term looks like I should plan on making my own. I’m in the middle of adding a hundred amp sub panel to my garage with the intent to power things like that down the road.
 
1 - 2 of 2 Posts
Top