Case Colt Ingersoll Tractors banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,383 Posts
Discussion Starter · #1 ·
The engagement rod on my '72 444 is worn through approx. 1/2 its diameter where it pushed against the loop in the engaged position. The engagment arm/fork I picked up ended up being the newer style which requires bushings. Anybody know what size these are? Figure I can figure out the lever end with some washers/spacers.
 

·
Registered
Joined
·
2,546 Posts
I don't know the size off the top but I would use a use a drill bit to measure the diameter. Haven't checked but I would be surprised if you couldn't find them at McMaster Carr or TSC.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top