Case Colt Ingersoll Tractors banner
1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
howdy,
my case 224 hydro came with a blade but no lift bar. I need a pic or diagram so I can fabricate something. Tried to swap the rear lift bar but that didn't work. I've seen a few photos that showed a round/tubular? lift bar but they were on different model tractors than mine. They also showed a different shaped rotating "lift plate" that drives the bar...but again photos were not of a 224 hydro. It seems most folks like to take pics from the left side of the tractor. Appreciate any info or comments.
thx,
mordamage
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top