[oleblu72]

Does any members have a picture of a combo holding valve? I'm trying to find out if my 448 has one, I went through the FAQ's but couldn't see the pictures, Thanks.

Mark

 

[Hydriv]

The photo below is of the combo valve
Do you notice the high hump where the motor ports are located?

No hump. No holding feature.

This is a standard travel/lift valve without the holding valve feature.

 

[oleblu72]

I'm gonna look at it again but I'll have to say it looks like the top pic Hydriv. Got it fired up today it won't stay running , took the fuel pump off it looks ok but I'll buy a kit for it. It sounds pretty good while it was running as I was spraying gas down the carb. Run another compression check while the motor was hot still had 110lbs in both cylinders, thanks Hydriv.

Mark

 

[oleblu72]

Yeah it looks like the one on top Hydriv thanks again.

Mark