Case Colt Ingersoll Tractors banner

1 - 5 of 5 Posts

·
Registered
Joined
·
160 Posts
Discussion Starter #1
I just picked up a 646LBH and the serial number tag is gone.From looking in parts book I believe it is a B series. Does anyone know if they were stamped anwhere else.

TED
 

·
Registered
Joined
·
579 Posts
Ted
Don't know if this applies, but it is a start.
I have a 91 Ingersoll 6018 and the serial number is stamped in the front, right above the front axle pivot pin.
If the engine is original, get the serial number and specs from it. The engine gurus might help get you in the ball park.
Danny
 

·
Registered
Joined
·
160 Posts
Discussion Starter #3
Thanks, I will check it. It does have CCK18-MS/28031 the spec # is different than the 1 in the parts book I downloaded.

Ted
 

·
Registered
Joined
·
352 Posts
Pictures are of great assistance. Many on this forum could narrow it down to a small range of likely model years. The more detail, the better. Good luck.

:trink:
 

·
Registered
Joined
·
103 Posts
Ted
check Onan model again...sure not ccka-ms?
I have 646bh and it says seris b on decal on lift arm right under 646 decal. Bob M
 
1 - 5 of 5 Posts
Top