Case Colt Ingersoll Tractors banner
1 - 6 of 6 Posts

·
Registered
Joined
·
2,348 Posts
:headscratcher: :headscratcher:

Hey 99

Both my old worn one and my new unused one come in at 1.4887 :headscratcher: :headscratcher:

Maybe both my Mic and verniers are out but I'm hoping that it's Billy and Boomer that are out :fingerscrossed: :fingerscrossed: :sidelaugh: :sidelaugh: :sidelaugh:

Another thing I noticed is that the new pin is a 1/4" shorter which will stop me from sliding the pin ahead to get new life from a used pin in the future. :headscratcher: :headscratcher:

:canada: :eh:
 

·
Registered
Joined
·
2,125 Posts
Discussion Starter · #6 ·
Stewart said:
:headscratcher: :headscratcher:

Hey 99

Both my old worn one and my new unused one come in at 1.4887 :headscratcher: :headscratcher:
Not sure that measuring down to "tenths" actually applies to axle pins. :lol:
Have 0 to1`s that will do that, but not 1 to 2`s and certainly not a set of verniers capable of that definition. I assumed that Sask was remote, but this gives new definition to time on your hands. :clap: :wave:
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top