Case Colt Ingersoll Tractors banner
1 - 6 of 6 Posts

· Registered
318 Posts
Discussion Starter · #1 ·
I have plenty of irons in the fire and just adding.

I do need a weight set up in the front of my 222 and 4016 when I get to hooking up the pto for tilling.
no doubt these things are light in the front end, so I am going to make a weight bracket.

should I just use the front mule to keep the snap fast? or would this rapidly wear the snap fast?
I have seen plates mounted to the side of the tractors frame, but I am not sure how dedicated I will be to drill holes in the frame :facepalm:

here are the weights, 25lb each
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.