H54 dozer blade question

2076 Views 2 Replies 2 Participants Last post by rennebew, Jan 22, 2012

rennebew

Discussion Starter · Jan 22, 2012

I recently picked up a H54 dozer blade. Part 16531 item 22 Link - lift has been replaced with a crude piece of angle iron. If someone gets a chance, could they measure the center to center dimension on a correct lift link. It looks like a simple part to make, i just want to have the right dimension to work to.

I searched for it but did not find a post discussing that particular part. Luckily it did come with the lift rod.

See less See more

Save

1 - 3 of 3 Posts

bhildret

· #2 · Jan 22, 2012

C16531 is available new from Ingersoll for the princely sum of $16.29 ... drop me an eMail to [email protected] if you would like to pursue one.

Brian

Save

rennebew

Discussion Starter · #3 · Jan 22, 2012

Thanks for the reply. I searched again and found a post from Feb of 2011 that shows a picture of the link beside a tape measure. Newbie mistake.

Save

1 - 3 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month