Case Colt Ingersoll Tractors banner
1 - 8 of 8 Posts

·
Registered
Joined
·
41 Posts
Discussion Starter · #1 ·
I first posted on the classifieds looking for parts for a project, and got a lot of help and insite. I've been reading old posts and archived documents to learn more about Case Ingersoll tractors in general.

I'm convinced I can install a 4 cylinder power unit in a 446, and I'm starting to gather parts to do that. I'm working with a friend that's installing a flathead Ford in an IR GT as well. Just novelty tractors, really, and we were inspired by the little hot rod tractor Grummy had at a tractor show. I'll keep a pictoral as we go along, and post from time to time. Maybe we shouldn't be doing this, but we can so we are.

I appreciate the insite so far, and I look forward to hanging out on here from time to time.
 

·
Registered
Joined
·
2,574 Posts
Welcome to the forum.
Glad to have you with us.

I think you would have to do an awful lot of fabrication to fit a 4 cyl in a 446. Not saying it can't be done,but would be a lot of work.

And by all means,if you do this,please do post some photos.


Maynard :canada:
 

·
Administrator
Joined
·
8,002 Posts
GRACB FAN: Welcome to the site, we're glad your here! :thumbsup: :thumbsup: :thumbsup: Please feel at home here, we have a great membership. Be sure to visit the comprehensive Technical Library and Tractor FAQs. There are also FAQs up top on utilizing the many features of the site. For pure reading pleasure please visit our History section on the Home Page. Look forward to talking on site! :usa: :usa: :usa:
:222: :446: Best Regards, Rich
 

·
Registered
Joined
·
973 Posts
I remember your last post, I would say don't rush the project, if done right it will be something special. You will have to be serious about the conversion , there will be a ton of fab work. Carry on and good luck , oldfrank .
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top