[dbeiter]

Hey guys, I recently picked up a couple of parts tractors (69 442 and 74 220) plus a large box of goodies... In this box was a bare holding valve, just the valve and 1 line, I am wanting to put this valve on my T-444, does anybody out there in CCI land have the 2 connectors that go between the HV and orbital motor?? PN 218-5062 and PN 218-5251.... Including you Brian??
Thanks!

 

[Hydriv]

You are actually looking for 1 double-ended connector and 1 steel line that does a 180. Lucky for you, that is the only steel line that is still available from Eastman and I do believe that the connector can be had as well. The other lines can be replaced by hoses and connectors.

 

[bhildret]

Yes, the fittings are available. Which line part number are you in need of?

Brian

 

[dbeiter]

You are actually looking for 1 double-ended connector and 1 steel line that does a 180. Lucky for you, that is the only steel line that is still available from Eastman and I do believe that the connector can be had as well. The other lines can be replaced by hoses and connectors.

Tom, I have that line... and also lucky for me.... I will need longer hoses, 19" longer to be exact........this is going on my "modernized T-90"

:sidelaugh:

 

[Hydriv]

Then all you need from Brian is the double-ended fitting which he can mail to you within a day or two. Yes, I knew what you meant when you referenced your T-444. At least you won't have to feel bad about breaking up a holding valve kit by parking the motor-to-valve lines on a shelf in your shop. :thumbsup: Nice find.

 

[dbeiter]

Yep, I figured you knew what I ment when I referenced my T-444, that was for Brian's benefit... If I would have gotten a complete HV set up, I would have sold the entire set up on Ebay :thumbsup: :sidelaugh: