Case Colt Ingersoll Tractors banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,383 Posts
Discussion Starter · #1 ·
Getting to the mower deck now and the holes in the mounting bracket are quite worn. When I lift up on the mounting bracket the front pivot pins and pins at the rear level adjust brackets hang at maybe a twenty degree angle. Thought I'd replace the forward pivot ones with shoulder bolts/washer/nuts and could tighten after leveling. The rear ones at the level adjustor brackets I'll have figure something simple out as there welded in the brackets.

Anyone have a simple solution or reason why I shouldnt do this?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top