Case Colt Ingersoll Tractors banner
1 - 3 of 3 Posts

·
Administrator
Joined
·
3,283 Posts
Hi Dave,
I was looking at my plow yesterday while fiddling with the clutch and it was bent in the same manner as yours was. I removed the piece and put it on my press and pushed it back almost straight. Got a clutch prob now and trying to figure out what the problem is.
Bob MacGregor in CT :headscratcher:
 

·
Registered
Joined
·
99 Posts
Discussion Starter · #3 ·
Bob, sorry to hear that but at least you know how to fix the plow. Mine worked great the few times I used it before I blew the engine. Now I'm trying to figure out what to do with the motor. It's going to cost $250 to machine it(bore, deck the block, shave the head, replace the valve guides) and then $180 for parts. I'm thinking about putting it back together with bubble gum and duct tape and hope for the best. Or buy another tractor and part out this one. Being laid off is not fun!
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top