Case Colt Ingersoll Tractors banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2,831 Posts
Discussion Starter · #1 · (Edited)
I thought I would pass this onto you all.
I needed new rubber engine mounts for my 224 restoration and found them as high as $54 each and as low as $10.89 each for the same exact product.
I ordered 4 through McMaster Carr at $10.89 each and received them today.
If your looking for mounts this is the place to go. I got them in two days.
Part# 6008K33
Look for:
Tear-Resistant Light Duty
Vibration-Damping Mounts
Here is the link.
http://www.mcmaster.com/#rubber-mounts/=wh1vyq

No more excuses to have flat washers holding the rubber mounts together. Oh and don't forget steel rivets.
There is also a seller on eBay that has them for around $12.95 ea.


Automotive tire Audio equipment Rim Wood Gas
 

·
Registered
Joined
·
75 Posts
Thanks MJoe. 2 of my old Deere's use them. They need them now.
BTW for my money you can not beat McMasters and Carr.
I ordered washer's and bearings for the poor mans PS, in the AM one morning, they were in my mail box the next morning.
 
1 - 2 of 2 Posts
Top