Case Colt Ingersoll Tractors banner
1 - 8 of 8 Posts

·
Registered
Joined
·
317 Posts
Discussion Starter · #1 ·
In need the two screws that hold the butterfly in the carb. This would be the butterfly for the governor. I have a 79 case 444. Kohler 14hp K321. Spec number 60324d, ser# 9515711, number on the carb 4705315. So if you have a few loose screws I could use them. Send me a PM with cost.
 

·
Registered
Joined
·
317 Posts
Discussion Starter · #4 ·
Thanks 99. I had already figured that out but no one has them. I went to two small engine repair centers today and they have one size larger. Thier idea is to drill and tap. I don't want to do that. I am going to go to the hardware stores tomorrow if I have time.
 

·
Registered
Joined
·
2,546 Posts
While I admit to going to the local big box stores more often I usually end up going to one of the local ACE hardware stores to find oddball stuff and am amazed at how often they have what I need.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top