Case Colt Ingersoll Tractors banner
1 - 4 of 4 Posts

·
Registered
Joined
·
38 Posts
Discussion Starter · #1 ·
can anyone put there come up with measurements for the mule drive bracket mainly looking for the hole measurements from front of tractor to hole them top of bracket to hole centers....
or if there is plans or blue prints can someone point me in that direction

I amaking a bumper/weight bracket. and have a flat laser at work I can use to assist in this build.

thank you!!! as always !!!!!
 

·
Registered
Joined
·
126 Posts
You can always check eBay. I found a mule bracket for $35 shipped. Sometimes they are $25. When considering my time to fab one, it made sense to buy.

I will try to take some measurements of the mule tonight or tomorrow morning.

Here is my weight project:


I had considered a bracket similar to @KennyP and stacking old brake rotors on it, but I stumbled on the scrap piece of steel pipe.

One thing for sure is I will never dent that 8" concrete filled "bumper." :)

Actually with the "quick release" nature the carriage bolts on my mule, it would be easy to fashion a removable bumper...probably a good idea since my wife ran into the house this year. o_O
 

·
Registered
Joined
·
202 Posts
Here are the measurements off of the RH discharge deck from my late model 4020PS.

Full measurement of all holes. Note that the front steel plate is .180 thick, these measurements are from the outer/front face, not the inner/back face:
Rectangle Slope Font Triangle Parallel


Pin offsets only:
Rectangle Font Parallel Slope Diagram

Wood Font Bumper Gas Automotive exterior



Top down view:
Font Rectangle Parallel Slope Number
Wood Road surface Fixture Brick Bumper
 
1 - 4 of 4 Posts
Top