:headscratcher: :headscratcher: :headscratcher:animalsonly said:
Post the Model and serial number is where I would start :thumbsup:
Will it turn the engine :headscratcher:
Now it won't start????
Ok got the screws for the butterfly. Reassembled everything and now it won't start. I assume it must be something to do with the safety switch in the deck arm. Can I cut and spice those wires together? It has been touchy all along and I'm tired of messing with it. Are there other safetys? Does the hood have to be on? The rear PTO arm is in the center position. All the wires are in the corect locations and clean.
1 - 8 of 8 Posts
Post the Model and serial number is where I would start :thumbsup:
Will it turn the engine :headscratcher:
If you look carefully at the wiring diagram you can see how to bypass the safety switches for testing purposes.
I'd rather not tell you how for legal/safety reasons.
I'd rather not tell you how for legal/safety reasons.
"79" k321 kohler 14hp.
Same as mine in my 224-79 :thumbsup:animalsonly said:"79" k321 kohler 14hp.
Battery + to coil +
To start
tap Battery + to starter solenoid small post
To start
tap Battery + to starter solenoid small post
:headscratcher: I believe you should have two small terminals.mikebramel said:Battery + to coil +
To start
tap Battery + to starter solenoid small post
The solenoid will not work unless it is Grounded :trink:
Running a direct wire will not work without the other terminal grounded :thumbsup:
Follow Chucks Directions :trink:
Good Luck
Update ,,,Re: Now it won't start????
I found that the switch on the end of the deck engagement arm does not activate when the deck arm is pushed forwand or pulled back, There is a lever on the switch that is riding on the end of the deck arm shaft that does nothing. If I hold it up I can start the GT. Am I missing something on the switch arm?
I found that the switch on the end of the deck engagement arm does not activate when the deck arm is pushed forwand or pulled back, There is a lever on the switch that is riding on the end of the deck arm shaft that does nothing. If I hold it up I can start the GT. Am I missing something on the switch arm?
1 - 8 of 8 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Case Colt Ingersoll Tractors
A forum community dedicated to Colt, Case and Ingersoll tractors owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
