Case Colt Ingersoll Tractors banner
1 - 3 of 3 Posts

·
Registered
Joined
·
317 Posts
Discussion Starter · #1 ·
Ok I have the litle plunger in the hole, mounted the points. They are in the metal frame properly. If I loosen the adjustment screw and put the points all the way in towards the motor, the points never open. I can tighten the points in this position and do a full revolution with the fly wheel and the points never open up. I can see the plunger move. Help call me if you can help 616-887-5344 my business cell Animals Only.
 

·
Registered
Joined
·
317 Posts
Discussion Starter · #2 ·
Engine K321 Spec 60324d, 14hp Kohler. So I took out the new points and put the old points in. I was able to set them to .018. I cannot get to .020. I am suspecting there is some ware on the little push rod behind it. I will have to order a new push rod and see if that helps. The new points would not set at all. They look like they were not formed/stamped properly.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top