Case Colt Ingersoll Tractors banner

1 - 5 of 5 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hello,
I am going to attempt to adjust the valves and install new points on my 646. Just ordered some parts and gaskets for it. I was looking through the reference section and I am getting confused as to how to determine which manual I need. I see several in the files for CCK onans but not sure how to determine the correct one.
20210327_125155.jpg
 

·
Registered
Joined
·
3 Posts
Discussion Starter #3
Thanks
So the MS following the CCKA does not matter you just go by the G at the end? Just trying to figure out how it works.
 
1 - 5 of 5 Posts
Top