Case Colt Ingersoll Tractors banner

Snowcaster down but driveway done!

2891 Views 10 Replies 7 Participants Last post by  xfolkboat
Hey guys,

We ended up with 18" or so of wet heavy snow here in CT. On my last long run down the driveway the caster stopped spinning. Luckily the 446 and plow was in the garage ready to take over, so most of the driveway is cleared. I just went out to the garage to see why the caster stopped. I was thinking I picked up a rock but there was no rock. The roll pin was sheared on the large pulley so it is an easy fix. While I am at it I am going to replace the 2 bearings tha go on the drive shaft as are on order. The caster performed flawlessly until the pin broke but I suspect because I pushed it so hard today the Caster did what it was supposed to and the pin sheared to avoid further damage.

More snow on the way for this weekend ! :letitsnow: :winterrules: :letitsnow:
1 - 1 of 11 Posts
I discovered a sheared rollpin (spirol pin actually) with the first snowfall of the year... Just took a bit of time getting the remnants out. Luckily it was an easy fix, and runs like a top...
1 - 1 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.