Case Colt Ingersoll Tractors banner
1 - 4 of 4 Posts

·
Registered
Joined
·
123 Posts
Discussion Starter · #1 ·
case 222 972233702
going to convert manual lift to hyd. lift. where does the lift cylinder bracket bolt to frame at? I got the rockershaft installed. Does the bracket go in between frame rails and bolt to where the pto guide bracket is. And if so how does the guide bracket bolt on with the cylinder bracket installed.
 

·
Registered
Joined
·
2,052 Posts
The lift cylinder bracket bolts to the frame just under the engine.The rockshaft has an offset bracket on it that the pump attaches to by way of a pin. Then there is another bracekt that is mounted on the frame just under the engine that the bottom of the cylinder attaches to. I thought I had a few pics that would help you but the best I can find are the ones from my resto project here.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top